Page 1 of 1

Very slow program start

Posted: Tue Aug 13, 2019 6:00 pm
by tonu99
I love FBackup, but it is extremely annoying that when I run program it takes at least a minute or two until it is ready for use. I see it it is trying to connect to mapped drives and stucks there. Couple of my mapped drives are through VPN (normally VPN not connected as I use these very rarely), but these drives are not included in any backup jobs. Please fix this bug. Program should not deal with these mapped drives if these are not included into backup jobs.

Re: Very slow program start

Posted: Mon Aug 19, 2019 7:38 am
by Adrian (Softland)

FBackup will check and will try to connect to all available drives, no matter if they are used or not by a backup job. FBackup has to list all available drives in case you decide to create a new backup job to any available destination drive.